2UUL DA02 Third Gen Oversize Press Clamp

A phone clamp can't reach across a tablet screen, and pressing glass by hand leaves uneven bonding and bubbles. The 2UUL DA02 Third Gen is an oversize press clamp built for both phones and tablets.

The listing describes adjustable pressure, ergonomic handles and non-slip pads, and calls this the third generation of the design. It gives no jaw opening, dimensions or list of changes from earlier versions.

When the oversize clamp is needed

• A tablet screen where the new glass lifts at one corner.

• Bubbles that show up across a large panel after lamination.

• A phone back glass that won't stay down while the glue cures.

• A tablet frame that is slightly bent and needs pressing flat.

Even pressure on big panels

Tighten in small steps and watch the glass. Large panels flex, so place a flat support under the device if needed. Check the pads for glue after each use, since a lump of hardened adhesive can mark the next screen.

Choose the DA02 when tablets are part of your work; for phones only, the DA03 Lite is the lighter clamp.