iPhone 16e / 17e CNC Donor Board

One donor board covering two models is handy for a shop's stock, and this listing offers just that for the iPhone 16e and 17e. It's a CNC-machined PCB made for reconstruction and data recovery on boards too damaged for normal repair.

It comes as an upper layer without NAND, or a lower layer in US or EU versions. The listing names both phones; the spec table lists only the 16e, so confirm against your board before ordering for a 17e.

Typical cases

• Board damaged beyond jumper repair.

• Shorts buried inside the layers.

• A phone dead after liquid.

• Data that must be recovered.

Tips for these models

Compare the customer's board with the donor before you start, checking connector positions and component layout, since you want to be sure the two match.

Move the needed components with controlled heat, then rejoin the board and run it on a bench supply. Test each function and keep the customer's original board safe until the repair is signed off. Record which parts went where, because a clear log makes later warranty questions far easier to answer and helps the next technician who opens this phone.