GVM T210 Phone Repair Soldering Station

The parts under a phone's shield are packed so tight that a full-size iron tip touches three at once. The GVM T210 station is built around the 210 tip size used for that micro soldering.

The listing describes adjustable, temperature-controlled heating and a compact body. It doesn't state power, temperature range, voltage, plug, tip type or contents, and only the model name points to the 210 system.

Where it fits

• Missing components beside the CPU.

• Lifted pads that need a careful jumper.

• A damaged FPC connector being replaced.

• Shorted filters near the charge circuit.

Before ordering

Check the photos for which handle is included and what mains voltage it uses. If you need published figures, the GVM H3 lists full specs and takes 210 handles too, along with T115 and T245.

With fine tips, use plenty of flux and short touches, and keep the tip tinned between joints so it heats evenly. Work under a microscope where you can, and preheat the board from below when a joint sits on a large ground plane, so the small tip doesn't have to fight the copper alone.